This machinery is born to satisfy the needs of the minimal lubrication in sectors. Its activity is based on a Spray System with carter and guarantees a minimal lubrication for both lower section and top section of coil and square cut. The PLC by SIEMENS with TOUCH PANEL operates on activation/deactivation of couples of lubrication points and it defines also the lubrication cycle of activated nozzles, starting from an external start button (a continuous signal, and not a impulsive one wired to the input of PLC). The motorized spray system with roller conveyor allows an optimal transportation of the metal sheet through the system.
It can be used for square cuts and coils lubrication up to 2000 mm width. If the oil used has a high viscosity or if it is subjected to physical/chemical variations because of low temperature, or in countries or plants where the temperatures are quite low; it is possible, as an option, asking for a thermal boundary installation inside the tank to have the lubricant in the best condition.
- It’s possible to save the recipes
- The system can operate in small areas
- Homogeneous and correct lubrication on metal sheets
- Reduction in lubricant consumption
- Increase of moulds lifetime
- Reduction in downtime for machineries
- It possible changing the quantities of lubricants depending on conveyor belt speed
- Immediate control of quantity used on metal sheets
- Easy to use
- Precise and long-lasting machinery